Command Start CS-580i FM Guida di Installazione Scaricare il pdf (Pagina 13)

Installation Guide P. 13

OPTION 2* Shock Sense MONITORED / Warn-away MONITORED

OPTION 3 Shock Sense MONITORED / Warn-away IGNORED

OPTION 4 Shock Sense IGNORED / Warn-away MONITORED

FUNCTION 5 – Ignition Valet

OPTION 1 Ignition Valet DISABLED

OPTION 2* Ignition Valet ENABLED

OPTION 3 Ignition Valet ENABLED

Tach Programming

About Tach Programming

If you press the START/STOP button before carrying out a Tach Programming procedure, the

System will make no attempt to start the Engine and the Parking Lights will give 5 flashes.

If order to carry out Tach Programming, you may simply follow the Automatic Tach

Programming procedure.

The System stores Tach settings regardless of the procedure used at the time of Tach

programming. All Tach settings are cleared when the System is reset. A new Tach

Programming procedure has to be carried out only if the System is reset.

Multi-speed Tach Programming

Tach signals may vary from vehicle to vehicle. The System is designed to read a wide range

of Tach signals produced by recent Ignition systems. There is no necessary manual

adjustment. Nevertheless, a Tach-programming procedure must be carried out every time

a new System Unit is installed. This is because the Tach signals of certain Ignition

systems are sometimes too low or too high for the System, causing failed start-ups at

various temperatures.

1. Flash the Hood Pin switch (see Table 1)

– The Parking Lights will stay ON for up to 20 seconds.

– Before the lights go out:

2. Press and hold the Brake Pedal,

– And simultaneously press the LOCK and UNLOCK buttons on the Transmitter:

– The Parking Lights will flash 4 times.

– Release the Brake Pedal.

3. Start up the Engine and allow the vehicle to reach regular Engine idle speed.

4. Once the Engine is running idle, press the Brake Pedal and keep it down until you

hear the Parking Lights Output flash 5 times.

– Release the Brake Pedal: Tach Programming is now complete.

The siren will chirp 1, 2, 3 times to indicate which tach mode has been detected.

Table 5: Multi-speed Tach Programming

Note

The L.E.D. follows the Parking Lights during the Transmitter Programming procedure.

At any time, close the Hood to end the Tach-programming procedure.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 21 22

Nessun commento

Command Start CS-580i FM Guida di Installazione Pagina 13